Editor's Note: This blog post was originally published in 2017, and was updated in April of 2019 to reflect updated information.
Dot gain is a tricky flexo printing defect with a variety of causes. As its name implies, the dots on your printed substrate increase in size. The printed result then comes out darker and sometimes fuzzier than intended.
That’s a quality defect you can ill afford. Unfortunately, with such wide-ranging causes, troubleshooting dot gain may take a little time and effort to solve. Let’s put the problem in perspective without wasting too much substrate and press downtime.
Here are the predominant causes of dot gain:
Flexographic printing is a pressure-sensitive process. It can be a root cause of dot gain and most of these 11 other flexo printing defects.
But how can you tell? Simply enough, lower the pressure from the print cylinder to the substrate and see if it corrects the issue. If pressure is the issue, your dot areas should come back into conformity.
Your sleeves or plates could be the incorrect thickness. Or aggressive inks, solvents, or cleaning solutions may have caused them to swell over time, leading to dot gain.
You’re more likely to avoid swelling by switching to in-the-round (ITR) elastomer sleeves. Elastomer’s properties are much more durable and resistant to wear. This allows:
Choosing the proper elastomer based on your ink types can help to solve swelling as one potential cause of dot gain.
Think about the difference between maple syrup and water. Ink viscosity is its resistance to flowing freely. The higher its viscosity, the more tacky and less likely it is to spread freely across the substrate. The lower its viscosity, the more likely it is to spread beyond intended printed areas.
So if you’re experiencing dot gain, the ink viscosity could be too low and spreading too much on the substrate. Monitoring the water, alcohol, or solvent content of the ink can help you adjust viscosity accordingly.
Dot gain may indicate too much ink is being transferred from the anilox to the image carrier and then to your substrate. You may have an issue with too much cell volume.
More volume equals more space on the anilox for ink to be picked up and transferred to the image carrier. Too much ink will build up there to eventually become larger-than-normal dots on the substrate. Use an anilox with a lower cell volume or a higher cell count.
Machinery wears down over time. It works the same with motor vehicles as with flexographic printing presses. A damaged gear, mandrel, or cylinder can impact how the image carrier contacts the substrate. Too much pressure because something is damaged or misaligned could easily cause a range of flexo printing defects, including dot gain and:
Inspect your printing press and perform routine maintenance (just as you would regularly clean and maintain your flexo sleeves and plates).
The dot on your printing sleeve or plate should not be smaller than than the cell on your anilox roll. If it is smaller, the dot can enter the anilox cell, where it will pick up more ink than intended. It’s a situation aptly called "dot dipping," which can cause more ink, in turn, to wet out on the substrate and cause dot gain.
A printing cylinder that is covered in excess dry ink is certain to create printing problems. Flexo sleeves and plates must be cleaned regularly with non-abrasive liquid solutions and brushes.
Mounting tape is inherently thin. But being too thick by thousandths of an inch can push your image carrier and ink onto the substrate more firmly than it would otherwise. That little bit of extra pressure is enough to spread the ink and create dot gain.
Of course, direct laser-engraved (DLE) in-the-round (ITR) elastomer sleeves don’t require taped mounting pre-press. “Load-n-Lok and you’re good to go!”
Dot gain isn’t a simple flexo printing problem. Its causes could be numerous, including issues related to press mechanics, ink management, cleaning and maintenance, and improper anilox.
But proper foresight and planning can prevent many of these causes. Proactive preparation (and the right equipment) can avoid press downtime needed to troubleshoot dot gain.